2018-2022 GSX-S750 Frame Sliders Installation

WARNING: The installation of all parts in these installation instructions must be performed by a qualified motorcycle mechanic who is using the correct tools and who understands the correct use of all tools required to complete the installation.
​
Tools you will need:
* Torque wrench
* Ratchet and short extension
* 8mm hex driver

Both frame sliders and mounting screws are identical for this model.

1. Start on either side of the bike by removing the engine mount screw (yellow arrow in the photo) using 8mm hex driver and ratchet. Remove only one side at a time.

2.  Install the frame slider and supplied screw/washer using the 8mm hex driver with the ratchet and short extension.  Tighten the screw to the factory torque specification (same as factory screw).​ ​​ WARNING: THE WASHER MUST BE ON THE SCREW BEFORE INSTALLING THE SLIDERS

3. After the first side is tightened, repeat steps 1-2 for the other side.


A single side can be purchased if damaged in a crash. Purchase here on our site.

Any questions can be answered by contacting us

---