
Suzuki Katana Frame Sliders Installation
WARNING: The installation of all parts in these installation instructions must be performed by a qualified motorcycle mechanic who is using the correct tools and who understands the correct use of all tools required to complete the installation.
Tools you will need:
* Torque wrench
* Ratchet and short extension
* 8mm hex driver
1. Start on the right (brake lever) side of the bike by removing the engine mount screw (red arrow in the photo) using a 8mm hex driver and ratchet. Remove only one side at a time.
2. Install the frame slider with the longer base and supplied screw/washer using the 8mm hex driver with the ratchet and short extension. Tighten the screw to the factory torque specification (same as factory screw).
3. After the first side is tightened, repeat steps 1-2 for the other side.
A single side can be purchased if damaged in a crash. Purchase here on our site.
Any questions can be answered by contacting us