Honda 929/954 Frame Slider Installation Instructions
1. Start on the right side of the bike (do not loosen both sides at once) by removing the engine mount
screw. This is the screw that goes through the frame and into the side of the engine- it is visible through the
opening in the side fairing.
2. The slider for the right side is slightly shorter than the left slider. Install the frame slider using the
supplied screw.
3. If using a torque wrench, tighten screw to 35 lb/ft.
4. Make sure the right side is tight before starting on the left side.
5. For the left side, use the same procedure- remove the engine mount screw and install the longer frame
slider using the same torque as the right side.
Any problems with the installation should be addressed by giving us a call- we will be glad to help.
To keep the original shine of your OES frame sliders, use a wax or polish on them every couple months. Minor
oxidation over time is normal, so the wax or polish will eliminate the oxidation.
If one side is damaged in a crash or drop, we offer single side replacements, instead of buying a complete set.
One-Eleven Sportbike
OESaccessories.com
wera416@twlakes.net
931-858-6654
Copyright OES Accessories 2003