2011-2012 Yamaha FZ-8 Frame Sliders Installation
Tools you will need:
* ratchet and short extension
* 8mm hex driver
Both frame sliders and mounting screws are identical for this model.
1. Start on either side of the bike by removing the engine mount screw (at point of arrow in photo) using the
8mm hex driver and ratchet. Remove only one side at a time.
2. Lightly lubricate (any type of automotive grease or oil will work) the supplied screw threads. Install the frame
slider and supplied screw using the 8mm hex driver with the ratchet and short extension. If using a torque
wrench, tighten bolt to 30 ft/lbs.
3. After the first side is tightened, repeat steps 1-2 for the other side.
A single side can be purchased if damaged in a crash. Purchase here on our site.
Any questions can be answered by contacting us
Tools you will need:
* ratchet and short extension
* 8mm hex driver
Both frame sliders and mounting screws are identical for this model.
1. Start on either side of the bike by removing the engine mount screw (at point of arrow in photo) using the
8mm hex driver and ratchet. Remove only one side at a time.
2. Lightly lubricate (any type of automotive grease or oil will work) the supplied screw threads. Install the frame
slider and supplied screw using the 8mm hex driver with the ratchet and short extension. If using a torque
wrench, tighten bolt to 30 ft/lbs.
3. After the first side is tightened, repeat steps 1-2 for the other side.
A single side can be purchased if damaged in a crash. Purchase here on our site.
Any questions can be answered by contacting us
